So last week my driver's door lock wiring harness on my '94 ZJ got melted when I tried to weld something onto my driver's door.

I went to the local Pick 'N' Pull today and cut off the door lock motor and key switch wiring harnesses from the driver's door of a '95 ZJ.

The part of the harness I cut off has four wires:

-Purple w/ Yellow Stripe
-Pink w/ Black Stripe
-Black
-Black w/ White Stripe

Where do each of these wires splice into on the driver's door wiring harness?

Any help would be appreciated!

Thanks (:

 

Pink/Blk connects to pin 1 of the drivers door motor and goes to pin 1 of the door unlock relay. Blk/wht connects to pin 2 of the drivers door motor and goes to pin 1 of the door lock relay. These wires also connect to all door motors and liftgate motor.

No Purple/Y but there is a Vio/Yel that goes from pin 7 of the Keyless Entry, Entry Module to pin 4 of the Vehicle Theft Alarm Module. Pin 4 is labeled Key Cyl.

Black is a ground that appears at pin 10 of the Entry Module and also pin 5 of the door unlock relay. It also connects from pin 5 to pin 4 of the door lock relay.

Hope this is not too confusing and is helpful to you.. If you want a copy of the wiring diagram, PM me your email and I will send it. It may be easier looking at the diagram and comparing it to what you have.