You're video is listed as "private".........won't play.

Still sub'd by the way.

 

Not sure what's up its been viewed on other forums. I'm look at it again

 

I fixed it. not sure how that happened lol

 

Works now.

What kind of sound deadener did you use?

 

The cheapest kind there is.

 

Ha, ha..........cheap is good.

I thought ya might have had something on top of the plywood like dynamat.

 

No need for it. The point of dynamat is to add mass to the sheet metal and change the resonant frequency. I did that with wood for a fraction of the cost. and dynamat is most likely the worst brand of deadener on the market.

 

Monoprice RCA's aint no joke man the jacket on these things are crazy. The grommet on the right is large enough to fit every brand of 1/0 I've ever used, I had to go up 1/4 because it was too damn difficult to fight them through. This is the metal perch my back seat rest on. Next weekend I am going to pull the carpet out and let it dry. I have a leak somewhere and found a few spots of rust I need to cut out and repair before I deaden the floor.

 

Getting the headliner ready to be redone. Still unsure what I want to do with it. Bedliner or fabric.

 

Lookin good

 

Thanks man. Still a long way to go. Need another 50' of power/ground wire. Gotta pick up the subs, build the ports, install the box so I can build trim panels, carpet/bedliner everything. Finish wiring. Move airbox so I can relocate my battery and add the 2nd alternator and then it should be done lol Then drive to north jersey to have her tuned by an SQ guru so my front stage is OFP!

 

Very low power test of my 10'' midrange off the Headunit receiving about 9watts.

 

Damn no love for the door test?

 

I love how clean that set up looks. I can't wait to see it all together. How long till you complete it you think?

 

Damn those doors are sweet!!!