Perhaps a little change.

 

Nice build I am doing the zone 3 " but I'm on 30s .

 

So far I am pretty happy with the zone lift. I just need a set of wheels with a nice off set.

 

Ok I ordered the speakers and ports to build my front doors. Going 3way active. should be something like this.

 

Testing out my new Head unit in the garage. pioneer 8400bh

 

Still not 100% on the substage yet. Now it all depends on how loud my doors are.
But I did order my frontstage finally and here is an update drawing of the door. I am going to run one PRV audio 10'', ported at 45hz with one 2'' aero from 50-400hz, one PRV audio 8'' sealed from 300-3500, and one PRV audio 4.5x4.5 horn on each door. The 10'' will see and 8'' should each see roughly 350rms per door. Yes I am porting my doors.

 

Here is the layout for each door and some close ups of each piece. The port is sitting on the cone of an 8'' woofer so you have something for comparison.






[IMG]http://sphotos-a.xx.fbcdn.net/hphotos-
prn1/737121_556520654377351_1577735748_o.jpg[/IMG]

 

 

http://www.facebook.com/pages/Audacious-Audio

 

Well idk...3'' aal...I went with the 4.5" zone with RE full leaf pack. I enjoy it but i cant compare to others since its my first lift and ive only had it for about a month. Hope you have fun with your bulid

 

I'm very content with the lift other than it leans to the left a little.

 

**** a jasper jig. this cost me about 11cents. Once I get all my holes marked and drilled properly I am going to put a thin piece of aluminum on the top and transfer the holes.

 

 

and the flush mounting begins.

 

That's a bit rediculous! Bet it's going to LOUD!