Ultimate XJ Build
#46
Junior Member
Thread Starter
#jeepxj #jeepcherokeexj #xjjeep #xj_jeep #xjjeeps #jeepxjcherokee #jeepxjcustom #jeepxj310 #jeepxjlife #jeepxjs
Last edited by Gotcha-Again-LOL; 01-17-2020 at 10:47 AM. Reason: New information
The following users liked this post:
thetastelingers (07-15-2019)
#50
Junior Member
What is the flange you have here to attach the 1350 u joint to the sterling. I’ve heard excursions and gas f250s has the 1350 joint flange but I haven’t found anything online that matches the threaded holes on the flat flange for my sterling. My 10.5 is from an 04
#51
Junior Member
Thread Starter
Well the flange we got was not correct...it was very frustrating trying to figure out the right flange to buy so we finally called Tom Woods and told them the year and the bolt spread and they sent us one with our driveshaft...I would call them and get the proper part number the first time...
The following users liked this post:
thetastelingers (07-22-2019)
#53
We had a Dana 44 from a 1977 Cherokee FSJ so we had to retube the axle to get the diff on the proper side. Got a sweet set of brackets and mounts for the XJ suspension mounting points. ready to go!
The following users liked this post:
Gotcha-Again-LOL (07-21-2019)
#59
Junior Member
Thread Starter
Well sadly after 10+ years of wheeling the XJ and a couple years on 1 tons we are officially parting him out and using his drivetrain for a new LJ project. Lots of great memories and fun was had! Time to move on to the open air!