Storm Trooper
Thread Starter
CF Veteran
Joined: Jun 2009
Posts: 3,071
Likes: 0
From: Denver, CO
Year: 1997
Model: Cherokee
Engine: 4.0
had these sitting for a while, and finally got the guts to slice my hood today.
got them prepped and painted.

so many great writeups, w measurements and everything, that it was actually fairly easy.
after the cuts were done. 5" from rear of the hood, 1" from center.

these pics were after i had pulled most of the tape off. i also put a large piece of cardboard under the hood, and a moving blaket over my windshield.

i noticed about a 10 degree drop.
got them prepped and painted.

so many great writeups, w measurements and everything, that it was actually fairly easy.
after the cuts were done. 5" from rear of the hood, 1" from center.

these pics were after i had pulled most of the tape off. i also put a large piece of cardboard under the hood, and a moving blaket over my windshield.

i noticed about a 10 degree drop.
Last edited by djlarroc; Jul 29, 2012 at 09:58 PM.
Thread Starter
CF Veteran
Joined: Jun 2009
Posts: 3,071
Likes: 0
From: Denver, CO
Year: 1997
Model: Cherokee
Engine: 4.0
thanks! took me about 6 cans of white to find the closest white. Krylon fusion dover white, at walmart $4.
Thread Starter
CF Veteran
Joined: Jun 2009
Posts: 3,071
Likes: 0
From: Denver, CO
Year: 1997
Model: Cherokee
Engine: 4.0
Member
Joined: Jan 2011
Posts: 202
Likes: 1
From: Maryland
Year: 2000
Model: Cherokee
Engine: 4.0 Litre Inline 6
Thread Starter
CF Veteran
Joined: Jun 2009
Posts: 3,071
Likes: 0
From: Denver, CO
Year: 1997
Model: Cherokee
Engine: 4.0
added a couple of minor mods, this wknd..
made some mounts for my jks discos.. mounted to front skid plate. tired of bungees/zipties.


31" tire in stock spare location.


hi-lift under bench seat

made some mounts for my jks discos.. mounted to front skid plate. tired of bungees/zipties.


31" tire in stock spare location.


hi-lift under bench seat

Thread Starter
CF Veteran
Joined: Jun 2009
Posts: 3,071
Likes: 0
From: Denver, CO
Year: 1997
Model: Cherokee
Engine: 4.0
thanks! found it on a forum. just need to pound the hump down a little, and the seat even latches to keep the hi lift tight, and the weight is pretty center. you need to remove the base, but comes off w/a cotter pin and fits easily under seat as well.
Newbie
Joined: Apr 2012
Posts: 9
Likes: 0
From: Toronto, Ontario
Year: 2000
Model: Cherokee
Engine: 4.0L
That is an awesome looking jeep. Like how you kept it looking stock. I have a 1998 Cherokee Limited that I am going to modify down the road - might borrow a few of your ideas. Cheers.



