well im not even near done,but i wanted to see if yall think im goin in the right direction atleast. i got this 1991 jeep xj Laredo from my step mom in feb,i didnt start workin on it till sept. but so far, i took my steps off,through on some 255/70/16 (30"x10.5") tires off a 99 zj and had to get 1.25'' wide adapters,i trimmed the bottom of my front fenders to make more room,i put led lights on my front bumper(small but insane bright) and im gonna finish trimmin when i get more dremel tool cut wheels

future projects
2inch lift
sye
dana 44 rear
snorkel
rhino line paint job
32" tsl's
quick front sway bar disco
just to much to list
sorry for the vagueness of my list im just not picky when it comes to it,i just take what i can get lol
sorry for the pic quality to,its all i have for now and my laptop isnt lettin me do what i want
im only 17 also

 

any body at all? i just wanna kno if im goin in the right direction,i dont want to do the wrong and get to far into it

 

sounds like a good plan to me dude. and the fender trim is right on. id say its a perfect cut. id remove the mushed in end caps. then you can wedge a bar in the end of the bumper and pull against the dented in spots.

 

yea,but i dont kno where to replace that vacuum football,i dont want that sitin out and get a hole in it or sumthin

 

1 no need for an SYE with only a 2in lift unless your rebuilding the case any way

2 32s wont fit with out cutting/bump stops. i ran 32s on a 2in BB and just pulled failrs and rubbed a lot. didnt rub on the street after it was cut. but would stuff them all the way into the fenders so you'll want some longer bumps.

other then that have at it

 

then i reckon ill save on the on buyin a sye and ill just do 31" tires instead

 

stock to stupid just go long arms and 33s from the start. cheeper in the long run

 

ill deff look into it,any recommendations on brands?

 

Clayton

 

ok thanx,ill check it out