project phoenix
#1
Newbie
Thread Starter
Join Date: Aug 2011
Location: nh
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
Year: 94
Model: Grand Cherokee
Engine: 5.2
project phoenix
firstly, my first jeep was a 94 grand cherokee v8 with a 3.5" rc lift, cut fenders and some cheap craigslist 33x12.5x15m/ts. wheeled it and used it for a daily driver until recently when it died on me(had 296xxx miles on it). the body is all rotted out so i decided its time to move on. picked up a 96 v8 zj from a friend for $600. high miles and the front axle is junk but the body/ undercarriage is spotless.
these are my plans for it so far....
-swap lift and front axle onto "new" jeep
-also have a 1 and 3/4" bb to throw on
-tnt customs unibody stiffeners, already have them
-torch beefy front and rear bumpers off old zj and weld onto new one
-tube rockers/ sliders tied into frame stiffeners
-contemplating long arms, i dont do any really crazy wheeling so im still on the fence
-cut fenders/ make fender flares that tie into body and sliders
-will be running 33s until i can get a set of 35s
these are my plans for it so far....
-swap lift and front axle onto "new" jeep
-also have a 1 and 3/4" bb to throw on
-tnt customs unibody stiffeners, already have them
-torch beefy front and rear bumpers off old zj and weld onto new one
-tube rockers/ sliders tied into frame stiffeners
-contemplating long arms, i dont do any really crazy wheeling so im still on the fence
-cut fenders/ make fender flares that tie into body and sliders
-will be running 33s until i can get a set of 35s
Thread
Thread Starter
Forum
Replies
Last Post
cpnwrench
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
02-15-2024 08:09 AM
azdave35
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
12
09-30-2015 06:25 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)