Sprayed some 3M rubberized undercoating on the trunk floor area to cover it. Also pulled the wiper motor as the intermittent function didn't work and it parked wherever the blades where when you turned it off without returning to zero. Bent the 3 "fingers" back down inside the motor cover plate and now it works perfectly. Ordered some new LED lighting for the interior.

 

Well, finally got around to pulling the dasbn the garage to go ahead and change out the steering stabilizer. Very thankful for my father in law and brother in law for the help

 

 

Good to see one coming back to new part by part...looking forward to following your thread

 

thanks, it's been fun so far, looking forward to the rest

 

Changed out the drag link today. That was the last piece of the steering "ends" that needed swapped out. Accidentally tore the rubber boot to one of the tie rid ends though so not sure if the whole tie rod end needs replaced now or not. As soon as I can change out the two U-joints that are at the axle ends I'll get her aligned.