Got this transfer case all done and installed. Was a pain to lift it in and bolt it myself. Would have got install picks but was too busy swearing and bleeding lol.

 

Also have a 4" lift on the way. That should be fun. Will use it this until I can buy a nice long arm lift. Just need to have it half a$$ ready for Gilbert Mn

 

Got the lift 4" rough ****ry lift gonna paint red (even though it will wear off quick I'm sure.

 

If it ever gets above freezing in MN-ND I'll be installing lift and rock sliders. Maybe this week it may hit 30°f wooo

 

Got some Iron Rock Sliders that just came in, and have a front locker coming in soon. Going to be war. Enough to work on the lift this weekend. "Very excite"

 

 

Got the rear end of the lift done those 19 year old rusted nuts are fun to get out. Bad pics but it's coming together

 

4" rough county lift installed.

 

Didn't get to my iro sliders today, but I swapped out all the speakers and gave her a bath.

 

Project Evil Dead....got some work done on me instead of the jeep. Evil dead chest piece coming together

 

Sliders on

 

So after that tcase swap it's felt weird. I put it in reverse and when it clicks in gear the Jeep hunkers down like pulls the body towards the ground 2 inches and same in driving it will lift ...its weird and seems really bound up trying to drive it forward or reverse. Also 2wd on the 242 doesn't work.....did I mess up? Any clues? Should I re pull the tcase and go thru it again? ?

 

Small update swapped in a 231 transfer case, got more evil dead tattoo work done, and put in a front end locker ( lunchbox spartan ) hitting the trails this Saturday finally to test it (break it) yay!