hey man, its all looking good!


can't wait for some wheeling pics

 

Got my shock tabs all burned out and shocks mounted today burned the axle mounts out of 1/4" plate and made the top mounts with a 3/4" piece of iron pipe:
Axle mounts:



Frame side mount:



All welded up:





Shocks mounted:



Also started to clean my wheels up for the rock rings and got one welded in:

 

Looked at the rock ring and just noticed I welded it in wrong so I cut it out and re welded it. Nothing like doing it twice

 

Got the front flares plated in today took a while to get the templates made and the 16ga. shaved down just right, and also got another rim cleaned up and rock ring welded in. Going to start painting both rear rims tonight

 

looks good, my only complaint though is that really tall spring perch. why did you go with that?

 

Man that thing looks incredible! I love it.

 

Thank you!

 

The perch is 2" over stock wasn't sure what lift I would need because those 63" springs are very flat and it's stronger than blocks for now but I actually think I am going to lower it 2" to get a better cog so those perches will be gone anyway

 

Hopefully going to Get the fenders buffed out and painted and going to undercoat the front and rear

 

Just got the fenders buffed out and painted have the final instal pics tonight

 

Picture of how they look

 

Love it mate great work

 

Thank you

 

Wow, looking great.

So what is the 2x6 welded to on the inside. I see that its welded to the angle iron you put on there, but hard to tell what the inside is welded too. I was thinking about doing the same thing but was running into that issue.

 

It's welded to the floor pans, the cross braces I put in, and it's also welded to the inside of the old rocker when the floor pans meet up you can kinda see it in this picture not the straightest line but I had to cut out the rust: