4x4 instalation
Alright so I have a 93 jeep cherokee sport I have lifted it up 4.5 inches and run 31s for now but it's a 2wd I was going to keep it for camping trips etc. but now I want to make it a build and turn it into a 4x4 what would you guys recommend? Should I go with the build or just buy a 4x4 and continue on.
|
Originally Posted by Betsy93
(Post 3102146)
Alright so I have a 93 jeep cherokee sport I have lifted it up 4.5 inches and run 31s for now but it's a 2wd I was going to keep it for camping trips etc. but now I want to make it a build and turn it into a 4x4 what would you guys recommend? Should I go with the build or just buy a 4x4 and continue on.
|
I just did a 4x4 swap into my 99 Two door, fairly straight forward and simple, i just bought a new tranny, i have a AX-15 in mine so i snagged a Ax-15 for 300$ and then a brand new in the box np231 for 140$ threw a SYE on it and after i finished with my engine build threw it all together and put it in, i decided to get boostwerks t case linkage which was a great investment, and for 50ish$ unbeatable. The only thing i havent done is the 4x4 pig tail for the transfer case to make the dash lights work.
|
Originally Posted by lil01cherokee
(Post 3102524)
I just did a 4x4 swap into my 99 Two door, fairly straight forward and simple, i just bought a new tranny, i have a AX-15 in mine so i snagged a Ax-15 for 300$ and then a brand new in the box np231 for 140$ threw a SYE on it and after i finished with my engine build threw it all together and put it in, i decided to get boostwerks t case linkage which was a great investment, and for 50ish$ unbeatable. The only thing i havent done is the 4x4 pig tail for the transfer case to make the dash lights work.
|
Sounds you up for the challenge, it should be fun! Welcome
|
I converted my 96 zj to 4wd. I found a donor jeep that had a blown engine. I took all the parts needed trans/t-case, front diff., driveshafts, shifter, shifter plate. I believe i listed all the parts… Very simple task. Took a total of 12 hours to swap. I replaced all the ball joints, U-Joints, shocks, all rubber components while i was in there. I also reinforced the trans crossmember, because i intended to use this as a rock crawler.
|
All times are GMT -5. The time now is 03:40 PM. |
© 2024 MH Sub I, LLC dba Internet Brands