Couple hours, drop the pan, inspect the damage, get some measurements, replace the blown out bearing/bearings put everything back together.

 

2-3 hours

 

lemme look in my bag-o-tricks-n ill get back to ya!

 

alright two questions, what color wire on the headlight harness is the highbeam? need to vamp tap it to trigger my relay for my driving lights. Second, part time light doesnt come on, if I run the cluster self diagnostic will that just check the light in the cluster? if so how can I test the switch in the TC?

 

Anything else I need?

 

not sure about the high beam wire - but use a multimeter and you'll find it

as far as the part time light mine doesn't work either - but it's the switch. You can test it by unplugging it from the TC sender switch and bridging the contacts of the connector with a paper clip.

 

Is it the same light on the dash for high and Low?

 

morning all.
I thought some evil drama happened when I didn't see the thread this morning. Turns out I went to the Mid-Atlantic room instead. Better refill that coffee cup.

 

yessir

 

Can you post a picture of the mounting points and how thick is the metal

 

Danke Herr dukie

 

the one i have for sale is in the back of my jeep, and it's raining. I have the same one on my jeep right now though. It's 1/8" thick and surprisingly beefy

here's how it the mounts are - 2 bolts though the framerail on each side

 

oooohhhhh--them turdy-trees just came in-n-they look sweet---need sum trimmin fo-sho!!

 

Good god what happened while i was gone?

 

Damn... anyas thread is gone... epic sad face...