Can you use the eauto works harness with sealed beams? And idk if my wire harness can be even saved now. Jake cut a bunch of wires and idk what he did so i may be ****ed.

 

Yes....you can

 

Yea mine was a bit more also. I used high quality tinned marine grade 10awg wire and shrink connectors, and loomed everything.

 

Yeah I make my own harness and stuff but he was asking for one so I told him who had one

 

Those shooters in the group, any one have any of the Magpul Dynamic instructionals? Id like to get my learn on and wanted to check to see if I could borrow before I bought them....

 

Green how much would you charge to paint 2 doors and a fender on my wj

 

McMaster Carr rocks.....

Found out the bearing I needed was the Omix Ada 18891.02. This cross referenced to 6207N.

It was $23-$32 everywhere on the net from 4x4 shops....

McMaster Carr had it for $12.78 shipped.

 

Nice score jimmy.
Nice and windy today, huh fella's?

 

I know this is going to be a fawking nightmare.

 

Re do the whole thing, ain't hard coach I promise

 

They are great for most things. Steel is not one of them lol.

 

He cut stuff past where the head light plugs are. Back by the computer.

 

Anybody know how much reveal there should be on a stock front drive shaft slip joint. I have about 1.25 inch gap and from reading that should be fine. I'm just looking for more specific numbers.

 

Before i order this and not the H4 conversion too(because i want my HIDs back soon) i can use the eauto works harness with sealed beam headlights? Jimmy said 'yes...you can' like it was a bad idea?

 

Purple is low beam orange is high beam