I need to clean mine with a clay bar then wax it. A lot of overspray to remove from when I painted the rockers with bedliner.

Lift is going on this weekend so it will have to wait. Priorities you know!

 

What size lift you doing?

 

4.5" with 33x12.5x15 mtz's

 

Here it is

 

Looks sweet! How much of a pain were the rear springs?

 

Leaf springs that is. I'm not dumb lol

 

Nice, is that at full lock? looks very close to rubbing the rear wheel well. Nice no-lift relocators in the back also.

In my experience it was very scary, hoping for the best expecting the worst, but everything for mine comes out easily surprising.

 

No, it is not at full lock in that pic. There is more room than appears in that shot but, it is close. The bottom portion of the fender was trimmed and folded over.

The rear springs weren't too bad. The front bolts were the hardest but, a little heat and a breaker bar they came right out.

 

Haven't been on in awhile guys...but I am in for the 25th. Looking forward to meeting other XJ's.

 

Just 5 more days!

 

I'm ready! Doing my lift (hopefully) tomorrow

 

Cool but you should wait till Tuesday. It's going to be hotter, lol. J/K. Good luck with it. Mine was a lot of work but well worth it.

So we have four definite for Thursday? Anyone post on FB?

 

What page would we post to? I'm not part of anything other than CF

 

If CF has a FB page someone could post there. I don't have FB so I don't even know if the forum has a page or not.

 

There is a FB page, I was just going off this. I'm going to try and replace my vacuum harness and TPS tomorrow, get the Jeep running right again before Thursday. I'll be there around 7:45.