Passenger motor mount bolts. Sheared off into engine block

 

Can you drill it out and out another screw in it?

 

That's what I tried. But I can't get it straight. I'm not even sure if an angle drill will work either.

 

all bolts are broke ?

 

Yea, the three on the passenger side

 

lower motor down as low as possible will it give you more room maybe

 

Thought about that also. You think if I take off the other motor mount and keep a jack under it. It will lower some more?

 

sometimes a small sharp punch and small hammer tapping at a angle you can spin the broken pc out

 

I don't get it. Sorry

Edit : nevermind, I understand. Ill be trying that also.

 

you take a small punch with a sharp point put it on the broken pc at a slight angle tapit with a hammer in counterclock wise direction trying to unscrew the broken pc out of the block they might be looser than you think in the block ,bont hit on very outer edge

 

Ok imma try that one tomorrow. If that doesn't work then imma try taking off the other motor mount to see if it will drop some more. Thanks Gary

 

if you can get it to spin a pencil with a eraser can bu used to help grab the end and spin it out...

 

id not loose other mount myself depending how much it drops id take the passenger side fan shroud loose and maybe let crossmember drop on that soide

 

Ok good to know. Ill try that instead then

 

if you cant get all of them out bolt up what you can and drive here