Only got a few pictures on my phone.

Didn't take my camera so no install pictures. I took some this morning though.
Ill put em up on my build today.

 

Here

 

Nice work table

 

Hey Dave is the stock x-member bolts the only thing holding the new x-member because with the mounts there you'll have a lot more stress on them.

 

No Brian welded the x-member to the unibody. That was a long 11 hour day but I definitely enjoyed it.

 

Looks good. Now do mine.

 

Hope it holds it is thin sheet metal after all.

 

Bought alternator off eBay, would not turn when arrived , noted case bent at mount contacted seller, did not get much of a response other than it worked when I sent it to you, pulled old alternator apart and swapped cases, now to install on the jeep to see if it works for a few rides

 

I've never bought anything off eBay cause I'm afraid ill get screwed over.

 

Had pretty good experiences, purchased 2 cars off eBay and many small things, sold a bunch of stuff also. Junk yards are not carrying older vehicles as much any more, they are all going to the crusher.

 

Not that thin.
It's plenty strong enough.

Probably stronger than 90% of the people's serious around here.

 

That's my painting table, take it easy!

 

Ha ha hey whatever works right

 

I'm not sure what that last line means but the steel is like 18 gauge and I'm not sure how you'd get good penetration without burning through. But if you're happy that's all that matters.

 

Was supposed to say probably stronger than 90% of the SETUPS