Great Lakes Wisconsin, Illinois, Kentucky, Indiana, Ohio, Michigan

XJ Wagoneer BAD ***!!! For Sale!

Old 07-15-2012, 06:58 PM
Thread Starter
Join Date: Apr 2009
Posts: 10
Model: Cherokee
Default XJ Wagoneer BAD ***!!! For Sale!

$3900 OBO, I will sell all my spare stock parts (which is a ton) and the ones at the bottom and the vehicle for $4000 out the door

This is a pretty recent picture, one difference is it now has the newer style mirrors on it. Note, this is a vehicle that will go wherever you want to go and could also daily drive as well. It runs GREAT! No mechanical issues whatsoever other than the AC which is easily fixable.

Jeep Mods
Body: 1986 jeep wagoner
Cut and folded rear quarter panels
Trimmed front fenders
Hood pins
Front Cage
Custom front Bumper welded into Cage
Rock Sliders welded to Unibody welded into front cage and welded into rear bumper
Rear custom wrap around Bumper with 3 foot unibody inserts
Metal Gas Tank skid plate
New style Cherokee sideview mirrors
Power Seats and windows

Engine Bay
Dual Electric Fans with Summit Racing dual thermostatic controller
Brown Dog off road motor mounts
Oil Filter Relocation kit
2 gauge Complete Custom Grounding Strap Kit
1988 Renix Head
1996 Engine Block (4.0L)
AW4 Tranny that has been rebuilt
K&N intake cone filter
Rusty’s Air tube
No exhaust leaks
ZJ Grand Cherokee Brake Booster, Master Cylinder and Prop valve
New style radiator with pressure cap
New Alternator, New Starter, New Water Pump, New High Volume Oil pump, New belts, new oil pan and seal, New rear main seal, new main tranny seal
Front Axle
Solid high pinion Dana 30 with Aussie Locker installed
Axle tube seals
New Spicer 760x u-joints on 2000 Cherokee Shafts
2001 Cherokee unit bearings
4:56 Gears
Completely rebuilt with Timken bearings and new seals
Rock Crusher Cast Iron Diff cover
WJ Grand Cherokee outer C’s
WJ Grand Cherokee dual piston brake calipers and rotors
360 degree welded tubes
New ball joints
JKS Unit bearing Spacers welded 360 degrees
Bar Pin Eliminator Kit
Crown industry 5 Layer Stainless Steel Brake lines extended for up to 8 inch lift
Rough Country 4.5” lift springs and shocks
2.5” Spring Spacers
JKS Quick Sway Bar Disconnects
Custom Sway Bar Drop Relocation Brackets
MOOG Sway Bar bushings
JKS WJ steering setup including Adjustable Drag link, Tie Rod and WJ TRE’s with tie rod flip
JKS weld on extended sway bar links
All brackets Fully welded
Rough Country Control Arm Drop Brackets welded to unibody
Adjustable upper and lower Control arms
Front axle relocated forward about 2 inches
Rear Axle
Complete replacement Chrysler 8.25 axle from 2000 cherokee
1996 Grand Cherokee disk brakes and calipers
Aussie Locker
4:56 G2 gears
Rock Crusher Cast Iron Diff Cover
Complete rebuild with Timken bearings and new seals
29 spline axle shafts
Shaved Bottom Diff for ground clearance
Lower shock mount Mod to increase ground clearance
Bar Pin eliminator kit
Crown industry 5 Layer Stainless Steel Brake lines extended for up to 8 inch lift
Complete replacement 4.5” lift springs
2.5” Greasable Lift Shackles

Transfer Case
NP231 with slip yolk eliminator kit and replacement speedo gear
Replacement front and rear drive shafts with all new lifetime warranty autozone gold u-joints
Direct shift rod upgrade

Steering Box is a new stock replacement with very few miles put on it
Drop Pitman Arm (3 or 4 inch I forget and it’s either Rusty’s or Rubicon Express again I forget which)
Kevin’s Off Road Drag link Drop Bracket
1988 Gauge cluster
SunPro Tachometer
-35 x 12.50 x 15 Goodyear Wrangler MTR Kevlar on steelie wheels 95-100% tread left no cuts or chunking
-35 x 12.50 x 15 Spare about 30-40% tread remaing (forget which brand acceptable condition for a spare)
-New fuel pump and sending unit
-Air condition/heater doesn’t work because heater core has a hole in it but compressor is good and you will get a used replacement heater assembly with good core in it
-complete set of doors come with it (was going to use to make half doors)
-Extra Hood

Additional Parts Not installed that are extra or for sale separately (make offer)
-Dana 30 inner C Gussetts
-JKS Lower Control Arm weld on Skid plates
-Rusty’s weld on top of axle tube Gussett
-Dana 30 Axle tube sleeves
-Billstein 5160 remote reservoir shocks p/n d4-bf5-a187-h1
-Steering Box stabilizer Bar
truck7575 is offline  
Old 07-15-2012, 07:18 PM
200sportxj's Avatar
Join Date: Apr 2012
Location: Minnesota
Posts: 226
Year: 2000
Model: Cherokee
Engine: 4.0l

Thats exactly how i wanna do the cage on my jeep.
200sportxj is offline  
Related Topics
Thread Starter
Last Post
Cherokee Chat
02-05-2019 03:58 AM
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
11-07-2015 01:22 AM
09-16-2015 10:29 AM
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
09-04-2015 11:05 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Search this Thread
Quick Reply: XJ Wagoneer BAD ***!!! For Sale!

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.
  • Ask a Question
    Get answers from community experts
Question Title:
Your question will be posted in: