B-TOWN!!!! in the house... yea i am back an this time with 2 xjs. 94 with 3'' lift an 33s . other is a 90 stock before the conversion... spunky i got some sick 33s pm me

 

need help guys!!!!! jeep wnt shift out of 1st unless done manually... any suggestions

 

hey hot boat you still got rims ? wanna get rid of my adapters?

 

Yea still got them, got tire kickers lol if you need or want them I still have them 1 guy says he wants them but has not sealed the deal. Will have till 8/2 and then thy will go away...back to UT

 

I'd disconnect your battery, wait about 15mins then reconnect it. Hopefully if your PCM had a glitch this will correct it.

Otherwise it could possibly be your Tranny TCU located under your dash.

 

hot boat whats yr asking price? an thanks i will try that

 

I put them up for 100.00 and i am selling the rims and you get 4 33x12.5 x15 BFG AT weather checked with about 40% tread on 3 and a bit less on 1 free the same low price and I will throw in at no charge free air what a deal.

 

A couple issues with my jeep I need advice/help with.
Okay so with the rc cross member you use the factory 2 bolt holes plus the 1 front of it on each side to bolt up the crossmember and side brackets. Well they bolts they provide you suck, they thread in perfectly until you go to tighten em then they just spin, won't get tight. Out of the 6 only 3-4 of em I was able to tighten the rest are on there they won't tighten and one on the left front hole I can't even get to start to thread on. What's a solution I can do fix this? I was thinking A. Retap the holes and use a different bolt or B. Drill some holes and throw some lock washers and nuts on the bolts in the frame rails but that means drilling holes in the frame rail.
What should I do???

 

Is it the bolt or the hole that's stripped?

 

I'm thinking its.bolt. ima try n use.the factory hardware. I don't.think the hardware they.supplied has the right thread.pitch

 

If it was me I would clean up the threads with a tap and try different bolts. I have a lot of factory bolts from all the work I did on mine if you need some.

 

That's exactly what I did. I ran a tap thru it and got some new bolts from ace and got it to work also put the rear leaves and stuff on it its 99% done I wanna take it to desert rat n have them double check everything since I'm ocd haha

 

 

Looks good!

 

Looks good Mario!