I know there was allready a thread about this but I didnt want to hi jack his thread so heres mine...lol

Im gonna put new door speakers and new sound bar speakers in the back. When I put my new speakers in should I just cut the wires from the old speakers and use thoughs wires on my new speakers or should I run all new wire? Im also thinkin about putting a 10" sub in the back with maybe a 500w amp. How would I go about wiring it up?

 

door speakers i used stock wires sound perfect i unpluged the beat tweeters under dash. I install a jy sound bar had to run wires for that cause my xjs speakers were in back. my amp fit perfect under back seat and ran all my wires under center console and then under either seat and up trim to the back. i little wire can be seen between the seat and the side but its got wire cover on it and looks fine.

 

oh the thick power cord to the amp wouldnt fit under the floor trim piece so its just pushed up agents the side to under the rear seat and has never gotten in the way.
I could proble take pics and figure out how to post them.

 

Yeah some pics might help...thanx

 

one more question...what would i have to do to fit 6 1/2 inch speakers in the front doors. Its a 96 2 door if that helps...

thanx guys