What door panel clips everyone using?
Thread Starter
Senior Member




Joined: Nov 2016
Posts: 804
Likes: 123
From: Homer Georgia
Year: 2000
Model: Cherokee
Engine: 4.0l
I've been using the cheap GOOACC brand ones on my 2000 XJ from Amazon but they are literally one time usage as always break even when removing the removal tool. Now there are 4 dark gray almost black ones still left guessing they are the originals ones and after about 500 times removing the panels (exaggerating) they have never break.Thanks!
Seasoned Member


Joined: Dec 2024
Posts: 305
Likes: 113
From: United States
Year: 2021
Model: Cherokee (XJ)
Those dark gray ones are likely the OEM clips they’re way tougher than the cheap replacements. If you can, reuse them or hunt down Mopar originals (part # 6503717). The aftermarket ones are junk and always snap. A salvage yard might have good OEM pulls too. Stick with the old grays if they’re still holding.
I buy Napa ones, really just cause I retired out of a Napa, and I think they hold up.
Thing is that they are not cheap like the ones on Amazon.
The bag of maybe 8 would probably cost a little less then the bag of 100 off Amazon.
Bring one to a Napa and ask to see the big blue binder.
Thing is that they are not cheap like the ones on Amazon.
The bag of maybe 8 would probably cost a little less then the bag of 100 off Amazon.
Bring one to a Napa and ask to see the big blue binder.
Last edited by Ralph77; Jul 1, 2025 at 04:34 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Skuggan
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
May 21, 2025 04:31 PM
XKCroc
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
Sep 23, 2024 03:44 PM
wbugar
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
Jun 2, 2022 11:23 PM
whatscooking
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
Jan 31, 2018 02:45 PM
fb97xj1
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
Jul 12, 2017 04:12 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)




