turn signal lever replacement

Reply Subscribe

Thread Tools

Search this Thread

Jul 30, 2010 | 05:05 PM

fort925

Thread Starter

Newbie

Joined: Apr 2010

Posts: 3

Likes: 0

Model: Cherokee

turn signal lever replacement

hey guy i got a 94 and the finger that push on the high low beam rod is broke and i cant figure out how to get it out of the column, im sure this has happened before if anyone can help me out here with this it would be great thanks

Jul 30, 2010 | 08:21 PM

warthog

CF Veteran

Joined: Jul 2009

Posts: 1,640

Likes: 0

From: Keesler AFB, MS

Year: 1998 XJ

Model: Cherokee

Engine: 4.0L

Quote:

Originally Posted by fort925

If its around the same as my 98, Take the lower dash panel off under you steering column, Then take the plastic off the column and you should see the whole assembly

Jul 30, 2010 | 08:33 PM

Andrew0257

Seasoned Member

Joined: Jul 2010

Posts: 491

Likes: 1

From: Central Florida

Year: 1999

Model: Cherokee

Engine: 4.0

94 is diffrent you have to take the steering wheel off.

Jul 30, 2010 | 10:09 PM

kbad

Member

Joined: May 2010

Posts: 155

Likes: 0

From: southlake, TX

Year: 1996 Sport

Model: Cherokee

Engine: 4.0L H.O.

hey man....been there done that!....there are two screws on the bottom holding the clam shell around the steering/turn switch lever/ignition....then, there is a secure torx 10 (i think!?!?) holding the connector harness/turn switch lever assembly in place (the torx bolt is parallel with the steering column and you get to it from behind)....good luck!