Ok so i had a code to change transmission output speed sensor. Well its 1 bolt to get it out but the bolt just keeps turning. So i pulled the whole piece out which included a gear. We have exhausted all options to get the bolt to unthread but the internal nut just keeps turning. Does anyone know what the part that the sensor plugs into is called?

 

What vehicle are you worling on? A Jeep Cherokee XJ?

What year, engine, transmission, and transfer case.

~~~~~~

If I think I know what I'm doing, I'd say you are working on a 1998 + Cherokee with an AW4 tranny.

It sounds like you are pulling the Vehicle Speed Sensor, not the tranny Output Speed Sensor. The VSS has a gear on the end of it and the Output Speed Sensor has no gear.

If you could post the actual fault code maybe we could help you out here.

 

Sorry 99 jeep cherokee 4.0 aw4. umm it think its called speedo gear housing cant find it anywere online.

 

Are you having a speedometer problem or a transmission problem?

What CEL code did you have?

 

It was P0720 which is output speed sensor. The bolt to take out the sensor was stripped. So i had to put the whole housing out to try to get it out which cant get it to budge. So i need to find the part that the sensor plugs into.

 

You didn't say what transfer case you have. Unless you have a 2WD setup, the 4WD AW4 transfer case adaptor is hard to find, and if you do find one they are big bucks. OEM part number 4897739AA. The dealer doesn't have them. Try ebay as a last resort.

I have a TC adaptor but you can't have it, it's holding up my spare 242. Nanner, nanner, nanner.

In any case, if you have a transmission extension (2WD) or TC adaptor (4WD). the bolt that holds the transmiision speed sensor on is M6x1.00x16.00 MM.

If you have the part out, maybe you should try to use a Helicoil to repair the bolt hole.