Hey guys, quick question. I went to do my trans mount this afternoon and after I dropped the cross member there were 4 spacers/washers, 1 on each bolt between the mount and the cross member. they were more of a spacer than a washer, square with a notch cut out to slide in around the bolts with the cross member already in. They don't look like it was just some previous owner trying something, they look "official".
My question is, did anyone else have these? are they needed? I put the mount back in without them, but haven't added the nuts yet so I can still jack up the tranny and put them in if they should be there, but I question them being factory. I also have not seen them in anyones write ups on how to do the trans mount. Thanks guys!

90 4.0 auto 4 door

 

so none of the 42 people that have looked at this have changed a transmission mount? :P just need a simple, yes mine had them or no it didn't. maybe I should have added a picture.......