spide gears rubbing center pin
#1
Senior Member
Thread Starter
Join Date: Dec 2010
Location: muskogee oklahoma
Posts: 574
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1988
Model: Cherokee
Engine: I6
spide gears rubbing center pin
recently picked up a disk brake 8.8 from the local pick and pull and after tearin it down to install an aussie locker i noticed the center has been rounded a bit... i have tried locating thinner thrust washers but i havent had any luck... i have read a few threads were people have ran aussies with a tighter gap between the cm gears but i dont know what the gap was between their spacers... what would be the best place to order thinne thrust washers or ahould i iut run it and see what happens
Thread
Thread Starter
Forum
Replies
Last Post
cr1d3r
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
09-29-2020 12:15 PM
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)