eric

Hi just brought a 1993 Jeep Cherokee 4.0l 5speed. At first it shifts fine but when i drive in after 15-20 minutes its impossible to get in any gear. Let it sit and it will shift again. I looked it up and it appears it might be the slave cylinder in the clutch doing this. Im not sure how to diagnose this since i know nothing about this clutch. Its internal i know but is there anything i can check before droppin the transmission? Also any info you cn give me about replacing the slave cylinder?

freegdr

i think on a 93 the slave cyl is mounted on the out side of trans pass side follown tke line from resivor by brake booster down id also check the fluid in trans mine had some water mixed in it when it got hot hard to shift drained and change shifts klike butter

freegdr

all th slave cyl does is push the pressure plate in and out

JeepingDan

94 and up they are. B4 you pull the tranny get a slave and a fork and convert it so you wont have to pull the tanny ever again when the the slave goes bad.