Signal From Crankshaft Position Sensor
#1
Junior Member
Thread Starter
Join Date: Jul 2011
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1987
Model: Cherokee
Engine: I6 4.0L
Signal From Crankshaft Position Sensor
Hi I'm doing some messing around and was wondering if anyone can measure a signal from the CPS while cranking (not running) on an analog meter. I believe it should be a small AC fluctuating voltage? I have an '87 Renix system, so it's not a Hall effect sensor. I know that much. Just trying to figure out how to tell if it's sending a signal I can pick up. (and I know I can check ohms to figure if the sensor is good or not, but that's not what I'm looking at).
Thread
Thread Starter
Forum
Replies
Last Post
JayneCobb
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
26
08-11-2020 03:22 PM
jmarzo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
09-03-2015 11:03 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)