James P

If its already got a SYE don't see why not....

motoandrew

ok so if its got a sye then it will. im not sure if it does or not. im guessing it doesnt so if i get a sye and the front driveshaft then that should work?

freegdr

front shaft will only work if its got a sye kit on it

motoandrew

ok thanks. are the sye kits hard to install

freegdr

that depends on you ability

freegdr

this is the cheapest ive found as a bolt on http://www.performanceoffroadcenter....aa9a25abfe6abc

motoandrew

thanks i was going to ask what the cheapest was. also im a certified motorcycle mechanic i know a little about trucks and stuff. im sure ill be able to do it

motoandrew

also are there any other vehicles that have about the same ds that i can get it off of that will fit? I might be going to pull a part soon and was wondering if there were anyother trucks i could possible get it off of if they dont have any there

Slick761

Measure it. I got a 31.5" d.s. out of a grand Cherokee. Different cherokees and grand cherokees have different lengths. I found a jy Cherokee with a 32.5 shaft but it was dented. Probably had a 44 but I didn't babe the money so I didn't look :-(

motoandrew

sweet thanks

Slick761

BTW I had to reuse my yoke. They were similar but different.

Slick761

You aren't using an sye are you?

motoandrew

yea i was planning on getting one

Slick761

Sorry that was for freegdr... my jeep was sitting around 7.5" with no sye and it was fine. I lowered it to 5.5 and its even better. The longer d.s. helped and I guess I got a good yoke.

motoandrew

yea was looking not to extend a driveshaft just to use the front driveshaft for the rear