question for those with a class III Curt hitch..
Thread Starter
Member
Joined: Feb 2010
Posts: 219
Likes: 1
From: Schererville, IN
Year: 1997
Model: Cherokee
Engine: 4.0
question for those with a class III Curt hitch..
is your receiver a bit loose with anything attached to it? I have a Reese ball attached to it, it slides in and a pin holds it in place, it fits pretty loose in the Curt receiver, enough to be annoying.. I was going to fix it by shimming with either tape or metal.. Just wondered if anyone else had the issue with a Curt hitch.
Seasoned Member
Joined: Jul 2010
Posts: 458
Likes: 0
From: Gobles Michigan
Year: 1997
Model: Cherokee
Engine: 4.0
Don't know about the curt but I have a putnum (sp) and it is also very loose. Temp fix duct tape. Good fix run a weld down each side and then grind it to fit tight.
Junior Member
Joined: Dec 2009
Posts: 69
Likes: 0
From: South Florida, USA
Year: 1995
Model: Cherokee
Engine: 4.0
is your receiver a bit loose with anything attached to it? I have a Reese ball attached to it, it slides in and a pin holds it in place, it fits pretty loose in the Curt receiver, enough to be annoying.. I was going to fix it by shimming with either tape or metal.. Just wondered if anyone else had the issue with a Curt hitch.
-E
Thread
Thread Starter
Forum
Replies
Last Post
Kydude7
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
7
Sep 20, 2015 06:35 AM
codykrr
Modified XJ Cherokee Tech
9
Sep 18, 2015 01:27 PM
mach3lude
Modified XJ Cherokee Tech
17
Sep 10, 2015 02:34 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)