Plastic fuel injector wiring housing issues
#1
Newbie
Thread Starter
Join Date: Mar 2016
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Plastic fuel injector wiring housing issues
So I bought a 2001 Cherokee sport and this long plastic housing that runs along the length of the engine seems to have melted off of where it was connected to the valve cover gasket. Does anyone know what this is called and where to find a new one?
#4
CF Veteran
Join Date: Sep 2009
Location: ☼ Blackhole Sun
Posts: 8,567
Likes: 0
Received 18 Likes
on
16 Posts
Year: My Jeep is a GMC
I'm sure that loom is NLA (no longer available). You could try a junkyard but it's so old and fragile you will probably break it into a million pieces taking it off.
#5
CF Veteran
Join Date: Oct 2015
Posts: 7,355
Likes: 0
Received 1,530 Likes
on
1,173 Posts
Year: 2000
Model: Cherokee (XJ)
I could not find a part # or what it is called after I busted mine in half when I removed it doing my 4 hole injector upgrade, valve cover gasket, replaced the heat shield, cleaned my throttle body, and IAC all at the same time. I reglued it but I am thinking the J.B. Weld I used will deteriorate from the heat over time. Might try to yank one out of the boneyard but I am betting what Turbo X_J said will happen.
Thread
Thread Starter
Forum
Replies
Last Post
bigredjeepbeautiful
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
02-24-2016 06:30 PM
Schneiderman
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
02-19-2016 01:31 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)