i pulled the abs pump relay , still drawing . i also put my lead on one of the puel pump relays terminals and it pulled 12.56 milli amps , so i went under the jeep and un plugged it and then i had no draw on the terminal ..... but then went back to the fuse and it was still pulling 11.55 milli amps . i havent disconnected any of the tiny wires from my alt but i just installed a new 136 amp one and it tested okay but i will still disconnect them . i had this drain befor the alt change also

 

pulled it and still have draw and i completly un hooked my alt

 

and my abs has been removed from the jeep also

 

were gonna need these twowhere did the alt enter the picture there ia a main abs relay pull that one its on the other side of the pdc see it

 

Wait a sec 12 milliamps right?


Ignition-Off Draw (IOD) refers to power being drained from the battery with the ignition switch in the Off position. A normal vehicle electrical system will draw from 5 to 20 milliamperes (0.005 - 0.020 ampere) with the ignition switch in the Off position, and all non-ignition controlled circuits in proper working order. The 20 milliamperes are needed to supply Powertrain Control Module (PCM) memory, digital clock memory, and electronically tuned radio memory.


is your battery in good shape?

 

its fuses 2 and 6 , i was reading the terminal numbers and not the fuse numbers lol sorry guys . even with fuse 2 pulled fuse 6 still pulls amperage . and yep i pulled the abs relay and it says abs relay right on it , that didnt change anything , hmmmmm

 

battery tests great . 2 year old optima red top , but if i have all my computers disconnected and my stereo out , shpould it not pull anything ??

 

Pull out the fuel pump relay, it splices into the circuit that feeds the pcm (fuse 6)

 

what does 2 and 6 power captianwoot

 

 

Fuse #2 is for the brake lamp switch and the abs module, #6 is pcm feed and fuel pump relay supply....

 

n0 2 powers brake lights no

 

you dont have the key in the on position do you? fuel pump relay and ecm and trans modules

 

brake lamp switch as in on my foot pedal ? , and yeah the fuel pump relay wiring is pulling 12.56 milli amps but when i un plug it it draws nothing but then i test my fuses 2 and 6 and they are still yanking 11.55 milli amps hmmmmmmm