jeeprider8894

checked relays they are good checked the fuseable links all good checked ignition module n coil replaced power there n power at distributer all fuses under dash are good ? need help i wanna drive my jeep

96rhino

most likely your Crank Position Sensor. I just replaced mine yesterday, same symptoms your experiencing. I'm guessing its a 4.0L motor since you didn't specify.

xj4life2

x2

jeeprider8894

yea how much is the sensor i wonder if there is a way to check it

offroadnut36

wait, im confused. your title says you dont have fuel injectors??

xj4life2

First find the connector unplug it them plug it back in 90% the jeep will start after this if not use a 3ft ext and give it a smack (its on top of the bellhouseing) then do the plug thing if still not starting change it . Thier about $40.00 and I always carry a spare. I ran fro three years doing the plug unplug thing. I hard wired it when I changed last itme

jeeprider8894

comes to find out computer is bad i took it out n half a quart of water came out > i cleaned it with alchol n put it back in walla it fired up but u cant give it gas injectors arnt gettin power but its idleing ?? wtf anyway i pulled all the plugs but two they killed it so 2 cylinders no injectors workin computer is shorted there is a 1990 in lkq can i use the ecu mine is a 90 no vin burnin or anything idk but yea tommorow i wanna go pull it