New Suspension Bushing Master Kit
#1
CF Veteran
Thread Starter
Join Date: Jun 2011
Location: Southern Idaho
Posts: 1,023
Likes: 0
Received 1 Like
on
1 Post
Year: 1994
Model: Cherokee
Engine: 4.0 L/242 CID I-6 High Output MFI
New Suspension Bushing Master Kit
Hey all.
I want to go ahead and replace all of my rotting bushings and grommets in my suspension with the following kit:
http://www.energysuspensionparts.com...?prod=2.18105#
Do any of you senior members with much more experience have any suggestions? The black ones are "graphite impregnated," but the red ones look a lot more awesome.
Do you know if these poly-u bushings make your ride a lot more hellacious, as in you feel every bounce and bump? The ride is already just bearable, anyway, thanks to the ancient rubber bushings.
It says I also need to buy the track bar bushings (only an extra eight bucks), and the steering stabilizer bushings, but I don't know which ones I'll need or where to measure the sway bar to determine which size I need.
I need some advice and help here, folks. Anything is appreciated.
Thanks,
Rob
I want to go ahead and replace all of my rotting bushings and grommets in my suspension with the following kit:
http://www.energysuspensionparts.com...?prod=2.18105#
Do any of you senior members with much more experience have any suggestions? The black ones are "graphite impregnated," but the red ones look a lot more awesome.
Do you know if these poly-u bushings make your ride a lot more hellacious, as in you feel every bounce and bump? The ride is already just bearable, anyway, thanks to the ancient rubber bushings.
It says I also need to buy the track bar bushings (only an extra eight bucks), and the steering stabilizer bushings, but I don't know which ones I'll need or where to measure the sway bar to determine which size I need.
I need some advice and help here, folks. Anything is appreciated.
Thanks,
Rob
#2
CF Veteran
Thread Starter
Join Date: Jun 2011
Location: Southern Idaho
Posts: 1,023
Likes: 0
Received 1 Like
on
1 Post
Year: 1994
Model: Cherokee
Engine: 4.0 L/242 CID I-6 High Output MFI
Any suggestions on the sway bar measurement? Apparently, there's 23mm up to 26mm, but I don't know where they get that measurement
Thread
Thread Starter
Forum
Replies
Last Post
ROCKRIDGE 4WD
Vendor Showcase
13
11-05-2019 10:58 AM
FS[SouthCent]: 4.56 gear set and master install kits D30 and D44
dcollins3208
Axles/Tires/Wheels
12
12-11-2015 11:49 AM
RWKHausSupply
Vendor Showcase
1
10-22-2015 01:11 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)