New little help from fellow Cherokee people
Thread Starter
Member
Joined: Oct 2012
Posts: 176
Likes: 0
From: North Carolina
Year: 1993
Model: Cherokee
Engine: 4.0
Need little help
Ok when it comes to vehicle I know my fair share but I get confuessed and need help.
Well I got a 93 4.0 Cherokee that blew a head gasket and I'm process of changing headgasket. Well all my rockers? (not sure right words) are nice and tight except cylinder 6 intake I can move side to side a little.(Has a little tick while running).... I checked and tightened the bolt but it was already tight so my question it would a worn lifter cause that and question 2 should I replace lifters while heads off.
I'm sending head off to shop to 3 angle valve job and head shaved and so on.
Well I got a 93 4.0 Cherokee that blew a head gasket and I'm process of changing headgasket. Well all my rockers? (not sure right words) are nice and tight except cylinder 6 intake I can move side to side a little.(Has a little tick while running).... I checked and tightened the bolt but it was already tight so my question it would a worn lifter cause that and question 2 should I replace lifters while heads off.
I'm sending head off to shop to 3 angle valve job and head shaved and so on.
Last edited by Tyler01; Apr 7, 2013 at 08:32 PM.
Thread
Thread Starter
Forum
Replies
Last Post
xjmachine
Fabrication & builders section.
25
Sep 27, 2015 08:22 AM
Hewittxj
Modified XJ Cherokee Tech
35
Aug 31, 2015 04:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)