I'm going through getting all this little things fixed on my project rig. I have the AX15 with a bad switch(I haven't pulled it to rebuild it yet). The person before me looks like they just bypassed it and cut the green wire on the harness side of the plug. What are my options when it comes to replacing the the 8 pin connector? Part number to order a replacement? Or U pull and get some butt connectors. I haven't undone the tape yet to see what it looks like but the Green wire with white stripe has been cut I was reading on the subject and it says the black wire the should be tied in but it was not cut. Just trying to figure out the best way to fix it right as opposed to doing some ghetto fab wiring job.