like the title says we have it loose but need help getting it to back out as something is in the way maybe the starter or something. I just have no room to swing a hammer to get it to move so i need a tip/trick that people have used to remove the upper arms on the frame end. Thanks in advance. ( also i did search but if you could point me to the right thread that would be great too.)

 

do you have access to a good quality air hammer, snap on or matco, that always works for me in tight spots.

 

Frame side or axle side? I didn't have any problems getting mine out when I upgraded them. Trying to figure out what it could be stuck up on.

 

i had issues with my passenger frame side upper control mount and got a closed end wrench, used a heavy hammer and swung as hard as a could with about 8 inches of room to swing. with the addition of pb blaster on the nut for about 30 minutes. it took a little while but finally broke loose

 

thanks guys i eventually got it out. I think the main colprit was that the track bar was putting such a load on it that it got stuck in the middle. I couldnt even get a punch in the middle to get it out. then of course after i removed that and cut/removed the bolt on the axle side i was able to move the upper arm freely letting that bolt move freely as well. 5 bucks for two bolts to replace those and all was well again lol.