I recently sheared my upper control arm's in half while in extreme articulation.I have 4.5" lift coil's with stock every thing else,beside's a dropped pitman arm.Beleive it or not a fellow wheeler with a welder and mad skill's was able to make some with my rear square stock steal bumper and the original piece's.
I now want to make extended one's,like what would come with a 4.5" lift.The problem is I need to know the center of bolt hole to center of bolt hole measurement of one out of a kit.
So if someone with a 4" to 5" lift could be kind enough to measure there upper control arm's center to center on the bolt hole's.I would greatly appreciate it.
Thank's for any help with this.

 

The info you're looking for is at the the bottom of this page> http://sisoffroad.com/forums/showthread.php?t=118
When you need some info, do a search under "Helpful Links".

 

Good find ol"blue. You are gaining knowledge at a very rapid pace, grasshopper.

 

Not really, but thank you kind sir. I'm not sure if the problem is cognitive or computer skills but I'm plugging away.

 

Seems to be no problem in either department.

 

Thank you very much that's what I was after.