so i put some holes in my gas tank today on accident and i just jb welded them, do yall think that will hold up? if not is there something better i should do? other than get a diff tank

 

Oooooh there has to be an interesting story behind this???

Yes..JB should work..if not, there is gas tank repair/plug putty you can p/u from Pep Boys or elsewhere.

 

lol well the story goes, i was trying to mount some extra tie down points in the back so i can strap down my tools and the screws wernt drawing tight so i pulled em and thought i smelled alot of gas so i took a coat hander and sure as **** it was covered in gas so i cut out a small piece of the carpet and its just two small holes so i went and got some jb weld epoxy putty and just pushed it into the holes a bit to seal it up. apparently there isnt any room at all between the floor and the tank!!!! too bad i learned this the hard way

 

 

lol yeah thats what i said man i was pissed. but hey jb weld can fix damn near anything right? i hope

 

BE REALLY CAREFUL WELDING THAT!!! Nuff said.

A "new" tank shouldn't be too expensive.