So I got a new harness but how do I install it how much do I have to pull out. The guy I purchased it from said it was right behind the cluster but I pulled that and couldn't find it

 

Bunp

 

I'm gonna guess you're talking about the harness plug that goes into the A/C Heater control? One plug goes to the fan control switch (most common to burn up) other goes to the back of the heater controls. Be careful not to loosen the copper pin connections on the switch when removing the old harness by being to rough, I'd recommend cleaning them some as well. If you do loosen one up (which you more than likely will) get a sharp point and press in on the little copper rivet holding it in (make sure to disassemble the switch first of course) to tighten it back down. Make sure you check both connections as well. Just cut the wires as close as you can to the old melted harness plug and match up the wires so the wires will connect in the same place as the old plug or else you'll be having your high/low/medium all screwy

 

Loosen what? If ur talking about the heater switch that melted with the plug so I replaced both and the new harrness didn't match so I just cut it and wired it together

 

so you got it fixed?

 

Yep