I have no way to extend the ones i have.

you have no tools ?

Plenty. By extending them, do you mean cut and weld longer center section to it?

Pm'd you

can you see the pic I posted?
yes cut in the middle and extend with tubing drill hole at each end and use a quick pin to remove all the parts are available at orchard or home depot

t

THat is the length eye to eye...

The links i have now have that bend in them like the factory ones have. I dunno if that will work. I can get discos like the one you have for $50 from RC. Not bad at all. Thanks for the mod suggestion.

will the extended links from warrior work with a 3inch lift? do i need the sway bar drop bracket?

Which links are you speaking of?

http://www.tellico4x4.com/product_in...1feda306f89d75

That's what i thought. Those will work fine with a 3" lift. That's what i was running and still am for a bit longer. No other modifications need to be done, just bolt on and that's it.

Note: sometimes their kit comes with metal sleeves for the bushing eyes, and sometimes it does not. You can just email them (their home page) and they respond quickly and will send you the sleeve immediately. Their CS is very good.

sounds good, ill order a pair! =)

do i really need the sleeves tho?

nvm just looked at them again, yes i do need them.

Not really but I find the bushing eye diameter a bit larger than the factory stud that's pressed in there. I couldn't really tighten the nut enough to eliminate slack or i'd smash the bushing too much. I bet if you contact warrior and tell them that you are about to purchase these links and know that they don't include the metal sleeve, they would probably send you some out right away and you'll get em in time the links arrive. Or go redneck and cut some tubing that fits