Are engine bay grounds the same for pre '97 and '97+?
I'm looking for something to pass the time later today after work and I've been trying to find a solid write-up about the engine bay grounding points for pre-'97, non-renix, 4.0's. I find stuff that points out 1 or 2 grounds, and I find full write-ups for the '97+ jeeps, but is there a place to find all of them in 1 write-up for the pre '97's?
I feel like I've seen them somewhere before but I can't seem to find them in the last couple days.... So if they're the same, I can use the '97+ grounds write-up I found in the "useful info here" sticky. Obviously I know about the main one for the battery, the one by the dip stick, one on the firewall for RF interference, and there are a couple more that hold several grounds, but not 100% on their location.... and I dont know if thats all of them.... I swore this was a sticky... maybe it should be? (for pre 97 non renix) Thanks ya'll. |
or even just the number of grounds works... dont need exact locations.
Not the number of grounding wires, but just the number of places the wires attach as grounds. What is it, like 4 maybe? 5? |
From the 95 FSM there are:
G101 ............ Near Battery G102 ............ Near Battery Same screw point next to the battery into inner fender G103 ............ Right Front Side of Engine, Behind Generator From generator harness to block G104 ............ Left Fender Side Shield, Behind PCM G105 ............ Left Fender Side Shield, Behind PCM Same screw behind PCM into inner fender G106 ............ Right Rear of Engine G107 ............ Right Rear of Engine G108 ............ Right Rear of Engine Below spark plug 4/5 area on block G109 ............ Right Front Side of Engine, Behind Generator Next to G103 G201 ............ Below Headlamp Switch Self explained G301 ............ Left Rear Quarter Panel Behind above |
Thanks mate!
|
All times are GMT -5. The time now is 05:57 PM. |
© 2024 MH Sub I, LLC dba Internet Brands