drivers side sway bar link stud broke
Thread Starter
Member
Joined: Sep 2011
Posts: 169
Likes: 0
From: Plymouth, MN
Year: 2001
Model: Cherokee
Engine: 4.0 L
drivers side sway bar link stud broke
The stud for the sway bar link, near the coil, on my driver side snapped during sway bar link removal.
The odd thing was that I had the bolt half out before the stud had snapped. Is there a way to get this stud out? It looks like it has some kind of torx head on the end of it, but there isnt much left on that side to put any bit. Are these welded in, or pressed in, or can i just hit them out with a hammer? Thanks.
The odd thing was that I had the bolt half out before the stud had snapped. Is there a way to get this stud out? It looks like it has some kind of torx head on the end of it, but there isnt much left on that side to put any bit. Are these welded in, or pressed in, or can i just hit them out with a hammer? Thanks.
Thread Starter
Member
Joined: Sep 2011
Posts: 169
Likes: 0
From: Plymouth, MN
Year: 2001
Model: Cherokee
Engine: 4.0 L
well found my answer on another forum
for the benefit of people searching in the future
http://www.rocklizardfabrications.co...r_endlinks.htm
for the benefit of people searching in the future
http://www.rocklizardfabrications.co...r_endlinks.htm
Thread
Thread Starter
Forum
Replies
Last Post
ammonllewis1
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
Aug 31, 2015 11:27 AM
ROCKRIDGE 4WD
Vendor Showcase
0
Aug 28, 2015 12:28 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)