Door grinds on fender when I open door?
#1
Seasoned Member
Thread Starter
Join Date: Aug 2008
Location: Illinois
Posts: 425
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0L I6
Door grinds on fender when I open door?
I have a 2-door '98 and for some reason, this just started happening, when I open the passenger side door, the door grinds and pops on the fender. I didn't get hit in the side (that I'm aware of). I did go wheeling about a week and a half ago but I am about 95% positive the door was fine after that.
I noticed that either the fender is pushed in a little bit or the door sticks out a little. I can't quite tell what it is but I'm pretty sure it's the fender.
Also, I am missing and have been missing the pin that prohibits the door from opening too far but it has always been like that and never given me any problems.
Is this a common thing with 2-doors or something?
How can I go about getting it all aligned and well again?
Thanks
I noticed that either the fender is pushed in a little bit or the door sticks out a little. I can't quite tell what it is but I'm pretty sure it's the fender.
Also, I am missing and have been missing the pin that prohibits the door from opening too far but it has always been like that and never given me any problems.
Is this a common thing with 2-doors or something?
How can I go about getting it all aligned and well again?
Thanks
#4
CF Veteran
Join Date: May 2009
Location: SLC, UT
Posts: 6,328
Likes: 0
Received 1 Like
on
1 Post
Year: 1989 2 door
Model: Cherokee
Engine: 4.0
Ya that's a comon problem with the 2 doors! The hinge is poorly welded to the body so over time the weld will break & the hinge will flex toward the fender! U can readjust ur door hinge shims & that sound do the trick!
#5
Seasoned Member
Join Date: Dec 2009
Location: Wichita, KS
Posts: 429
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0l I6
My 4dr has the same problem. I took the fender off to bend it back and then when I put it back on and opened and shut the door once it bent it back haha. My huinges have came off the weld as well.
#6
CF Veteran
Join Date: May 2009
Location: SLC, UT
Posts: 6,328
Likes: 0
Received 1 Like
on
1 Post
Year: 1989 2 door
Model: Cherokee
Engine: 4.0
Ya I tryed the same thing the right fix woud be to weld it back up! In fact extream 4x4 tv show did this on a XJ a few years back, but I'm sure u could find the vid. if u surf the web!!!
Thread
Thread Starter
Forum
Replies
Last Post
nrwphoto
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
09-09-2015 10:41 PM
Mmll52
Modified XJ Cherokee Tech
6
09-02-2015 10:01 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)