Does this look like it could have damaged the unibody?
#1
Junior Member
Thread Starter
Join Date: Aug 2011
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Does this look like it could have damaged the unibody?
I just finished repainting and reinstalling the bumpers last weekend. So much for being done that project. Sorry about the lousy photo quality but it was dark when I took this last night after getting hit. I can't open the hatch as the edge of the bumper was pushed up against it.
I think everything looks ok underneath, but is there anything specific I should look for?
#2
Does not look like it should have caused any unidody damage. The stock bumpers are not very strong and bend easily even with a light hit. The bumper is easy to remove by taking out 8 15mm bolts that hold it to the body. Use some PB Blaster to soak the bolts a few times before trying to remove though. They have a habit of getting a little rusty with age and will break with to much force.
#3
Junior Member
Thread Starter
Join Date: Aug 2011
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Yep, had the bumper off last week to repaint it and clean up rust and the bolts were a bit of a pain. I ended up buying new speed nuts after breaking a couple of them.
Lucky I got the bumper back on before getting hit last night. I am still torqued off about having to chase down the other driver as she tried to make a run for it... always makes for a great evening .
Lucky I got the bumper back on before getting hit last night. I am still torqued off about having to chase down the other driver as she tried to make a run for it... always makes for a great evening .
Thread
Thread Starter
Forum
Replies
Last Post
Cane
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
23
12-11-2015 11:09 AM
Freakn
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
52
10-04-2015 06:34 AM
Joshuapn
Other Vehicles. Other Jeep models & cars and trucks of other makes
1
09-25-2015 08:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)