Need help replacing turn signal lever on 92 xj
#2
Member
Join Date: Feb 2010
Location: Tacoma, Washington
Posts: 199
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1995
Model: Cherokee
Engine: 4.0 inline 6
I'm assuming the lever itself physically broke? Or is it an electrical problem?
I've done this before to my '95.. but it was years ago. If I remember right, you will need to remove your steering wheel. And replace the entire unit, or housing that includes that switch, and the electrical components.
Honestly.. I'd suggest grabbing one off a junked XJ. Save the Steering collumn housing and hardware.. in case you strip, crack, or lose any of the original.
Also, when you do the reinstall. I'd suggest adding a little dab of dielectric grease to any contact points you can reach. Doing this will help keep moisture from getting in and causing early corrosion.
I've done this before to my '95.. but it was years ago. If I remember right, you will need to remove your steering wheel. And replace the entire unit, or housing that includes that switch, and the electrical components.
Honestly.. I'd suggest grabbing one off a junked XJ. Save the Steering collumn housing and hardware.. in case you strip, crack, or lose any of the original.
Also, when you do the reinstall. I'd suggest adding a little dab of dielectric grease to any contact points you can reach. Doing this will help keep moisture from getting in and causing early corrosion.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
bajdzo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
08-28-2010 08:55 AM
jievaz
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
08-20-2010 11:13 AM
fort925
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
07-30-2010 10:09 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)