building suspension arms
03-11-2010, 02:13 PM
#1
Seasoned Member
Thread Starter
Join Date: Feb 2010
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
building suspension arms
For those of you that have built your own arms, long or short, where did you order the ends and bushing from? Looking for a good place to get them so I can start on my own after I get a lift in. Thanks
03-11-2010, 04:53 PM
#3
CF Veteran
Depends on what you are using for bushings and joints. Several companies have builder parts. JKS is a good one. I got stock bushings from 4WD
03-11-2010, 08:47 PM
#5
Senior Member
Join Date: Jun 2009
Location: Blakeslee, PA
Posts: 750
Likes: 0
Received 3 Likes
on
1 Post
Year: 97
Model: Cherokee
Engine: 4.7
I sell, use, and/or install joints from Summit Machine, Ballistic, or Rubicon Express.
For poly bushings, I use Ballistic & Summit.
Rubber bushings ... I do a little bit of quasi custom work using RE parts & the OE LCA bushing.
If you'd like some numbers --- figure out what you're wanting and give me a shout. I think you'll like what you see.
Joe
For poly bushings, I use Ballistic & Summit.
Rubber bushings ... I do a little bit of quasi custom work using RE parts & the OE LCA bushing.
If you'd like some numbers --- figure out what you're wanting and give me a shout. I think you'll like what you see.
Joe
03-11-2010, 10:23 PM
#6
Seasoned Member
Thread Starter
Join Date: Feb 2010
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Thanks, when I am ready to get started I will definatly contact you.
I sell, use, and/or install joints from Summit Machine, Ballistic, or Rubicon Express.
For poly bushings, I use Ballistic & Summit.
Rubber bushings ... I do a little bit of quasi custom work using RE parts & the OE LCA bushing.
If you'd like some numbers --- figure out what you're wanting and give me a shout. I think you'll like what you see.
Joe
For poly bushings, I use Ballistic & Summit.
Rubber bushings ... I do a little bit of quasi custom work using RE parts & the OE LCA bushing.
If you'd like some numbers --- figure out what you're wanting and give me a shout. I think you'll like what you see.
Joe
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)