broken water temp sensor
i swapped my idiot light cluster out a couple months ago. switched the oil pres sensor. but in the middle of doing my temp sensor the top part of the sensor snapped off. its flush at the head now with no way to grab it.
any suggestions beyond and aftermarket? maybe another place to hook the info wire into or the sensor?
any suggestions beyond and aftermarket? maybe another place to hook the info wire into or the sensor?
Drill and extractor (EZ Out), left hand drill bit. Be sure to use center punch as close to the center as possible, unless its already hollow, then use an Ez out. If its brass then it may be more of a challenge.
CF Veteran
Joined: May 2009
Posts: 1,844
Likes: 4
From: Glen Burnie, MD
Year: 1994
Model: Cherokee
Engine: 4.0 H.O. K&N, Borla headers, custom down pipe, magnaflow hi-flo cat, flowmaster to turn down tip
you can try taking a flat head and tapping it till it comes out, but the ez out is probably your best bet.
Thread
Thread Starter
Forum
Replies
Last Post
Programbo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
23
May 23, 2024 07:20 AM
shelby5041
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
39
Nov 7, 2015 01:22 AM
Ye Ol' Cherokee
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
Oct 9, 2015 10:29 PM
Soilman
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
Sep 6, 2015 07:51 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



