bottom end rebuild
#1
Junior Member
Thread Starter
Join Date: Jul 2013
Location: Nashville
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Year: 91
Model: Cherokee
Engine: 4.0
bottom end rebuild
Hey there guys I was wondering if its possible to but new rod bearings in with our pulling the motor and if so whats the best ones to use thanks.
#2
CF Veteran
Join Date: Jul 2012
Location: SD
Posts: 1,395
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0
Yes, it sure is possible. Not sure what the preferred brand is, though. Maybe someone else will chime in. I'd just go with any reputable name brand.
#3
Seasoned Member
Join Date: Jun 2009
Location: newberg
Posts: 327
Likes: 0
Received 1 Like
on
1 Post
Year: 1988
Model: Cherokee
Engine: 4.0L
Can be done no prob. And all i run is Clevite. Why are u changing them? If its noise then u need to pull the motor and get the crank checked/turned and polished. Dont bandaid it. If its just a mileage thing then go fer it! Just Plastigauge each rod bearing and make sure theyre in tollerance.
Thread
Thread Starter
Forum
Replies
Last Post
lgrant
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
07-05-2022 12:19 AM
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
CAT_Tech2
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
67
09-18-2015 08:26 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)