So I'm bedlining the interior of my jeep and ran into a few problems. First theres this foil stuff(pic 1) on some spots of the jeep. What the best way to get it off to bedline it it is glued on? Do I have to remove the center console? If so how? Where the front passenger puts there feet theres a rubber liner and a bag of cotton or something( pic 2), is it safe to pull this out? Under the rear seat theres a 2nd piece of metal on top(hard to explain its pic 3) do I remove it or work over it? Thanks

 

did you search to see if someone else had this issue?

 

Yes these are the questions I still had after reading a few threads on it

 

Bedlined interior and quarter panels. I have some herculiner left over can I hammer the can shut and use it another time?

 

brining up an old thread so I dont have to start my own, searched and didn't come up with much (I suck at using the search button). Im about to use roll on bed liner on the inside of my XJ, what prep do i need? do i just need to wipe down the interior with paint thinner? do I need to sand the old paint? shoot primer? Any help would be welcomed.

 

scrape off all junk, clean surface and scuff with scotch brite pad, then wipe down with acetone. Apply bed coating and let it dry.

 

Cool thanks, I hope it takes and doesn't come up.