Ball Joints
Hey I am trying to replace the ball joints on my jeep and I think that when I was putting in the lower ball joint it went in strait but the rod bent. Does this look right?..
https://cimg5.ibsrv.net/gimg/www.che...3ca8655c20.jpg |
https://cimg9.ibsrv.net/gimg/www.che...7ea00e4c19.jpg
Typical ball joint cutaway. Hope that clears any confusion. It's a "Ball" joint. It's supposed to be able to move like that. |
Yep. Its suppose to give your steering a little flex. You should be able to push it back and forth with a little resistance
|
If it didn't move around any then you would have a problem.
|
Is "dumb" purposely spelled incorrectly in your sig line? Serious question.
|
All times are GMT -5. The time now is 07:09 PM. |
© 2024 MH Sub I, LLC dba Internet Brands