Autozone motor mount problems
#1
CF Veteran
Thread Starter
Join Date: Sep 2010
Location: Coos Bay, Or
Posts: 1,024
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
Autozone motor mount problems
Alright so I have an 90 xj 4.0 and I'm replacing the motor mounts and I ran into a problem. The replacement mount seems too thick to fit into the engine mount bracket. I got my mounts from autozone part number 2572. Anyone else have this problem? Everything about it looks the same as my old one, except the part where the bolt goes too the engine, like i said it seems to be thicker. Thanks for any help. I need to get my jeep going!
#2
Newbie
Join Date: Oct 2010
Location: Lovington NM
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Cherokee
Engine: 4.0
motor mounts
I just did mine on my 89 and got them from zone. I had the same issues but it just took some time and a some thinking but they went in. I raised mine up enough to put the mount on the engine first then sat it down slow and with a little work I got it down on the bolt . Took a little longer then it should but it was the first one I had done on the cherokee.It was the pass side mount. Gonna do the other side soon and it looks like it might be a fun time.
#3
CF Veteran
Thread Starter
Join Date: Sep 2010
Location: Coos Bay, Or
Posts: 1,024
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
Haha alright if you got it then I have hope, I actually started with the driver side, it wasnt too bad after your remove the airbox, however watch out for that nut you have to take off from the bottom, that how stud broke loose from inside the mount soo it was just spinning with the nut, a few days later i finally got it off, ended up cutting the whole nut off.
#5
CF Veteran
Thread Starter
Join Date: Sep 2010
Location: Coos Bay, Or
Posts: 1,024
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
Ha! nismo5 I wish mine went as well as yours, you didnt have any problem with it? Mine still seems to wide to go into the engine bracket, and i checked the part number and its right.
Thread
Thread Starter
Forum
Replies
Last Post
Blackcherokee290
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
27
07-26-2022 07:52 PM
nicksan
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
08-21-2015 11:59 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)